Rockwell Automation 2705 RediSTATION Operator Interface User Manual - Manual (Page 39)

Publication 2705-UM001A-EN-P
Building a Custom RediSTATION 5-3
Assembling the
RediSTATION To assemble a RediSTATION device:
1. Mount the 800T devices to the enclosure cover. Refer to the
instruction sheet that accompanies each device for mounting
instructions. All of the devices should have the connection
terminals on the same side.
2. Connect the 800T device terminals to the I/O connector using
the I/O cables. An I/O cable consists of a twisted (red/black)
wire pair. Each set of contacts or pilot light connects to an I/O
cable.
Lamp Reflector
(Lamps only)
Locknut
Thrust Washer
Trim Washer
or Legend Plate
Cover
with Gasket
Gasket
Bonding Spring
Gasket
Orient device connection
terminals as shown.
ATTENTION
!
Do not connect I/O pins to external devices or
control circuits. Connecting pins to these devices
will damage the circuit board.
I/O Cable
I/O Connector