Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install - Manual (Page 11)

4Ć1
4.0 INSTALLING THE
SINGLEĆUSER EXECUTIVE
Use the following procedure to install the Executive software
(M/N 57C600, 57C601, 57C602). This procedure will install the
Executive files and automatically create a Windows program group
containing the AutoMaxĆrelated icons.
During the installation procedure, the following subdirectories will be
created on the hard disk if they do not already exist:
<DRV>:\<RPE>\<AMX3>
<DRV>:\<RPE>\<AMX3>\TEMP
<DRV>:\AMXWORK
Step 1. To begin installing the Executive software, insert the disk
labeled 1" in floppy drive A: or B:.
If you are installing from the Windows Program Manager application,
type the following after selecting Run from the Files menu:
<DRV>:\INSTALL.EXE
where:
<DRV> is the drive in which you have placed the disk.
If you are installing from Windows 95:
Click on start and choose RUN; type
<DRV>:\INSTALL.EXE
where:
<DRV> is the disk drive in which you placed the disk.
Before installing any files, the install program will display two
messages. The first message describes the type of installation
(Single User or Upgrade Single User); the second lists the number
of disks required for the install procedure and the amount of hard
disk space required for the Executive software.
If you are installing the upgrade software (M/N 57C601), you will be
prompted that the install procedure requires a previously installed
copy on the hard drive.
Step 2.
You will be prompted for the drive and subdirectory in
which to install the software. The defaults are as follows:
<DRV>:\<RPE>\<AMX3>
where:
<DRV> is the hard drive where Windows is installed
<RPE> is the ReSource subdirectory
<AMX3> is the AutoMax V3.x subdirectory
You can make changes to any of the above parameters.
<DRV>:\AMXWORK will be the default working drive and
subdirectory. If you need to change the default, you must do so at
the Setup menu in the Executive software.
Step 3.
If AutoMax task skeleton files (SKELETON.*) are found in
the install directory, the Install procedure will display a
message stating that the existing AutoMax task skeleton
files (SKELETON.*) have been reĆnamed to USKELTON.*.