0 installing the optional sharedćuser dps software – Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install User Manual

Page 21

Advertising
background image

8Ć1

8.0 INSTALLING THE

OPTIONAL SHAREDĆUSER

DPS SOFTWARE

This chapter describes how to install the sharedĆuser version of the

DPS software (M/N 57C650). The sharedĆuser DPS software allows

up to five users to simultaneously run the Executive software with

DPS software options. The software is installed on the network

server only.
Note that the individual DPS software options are not included in the

sharedĆuser DPS software. The options must be installed separately

after or before the sharedĆuser DPS software.
Prerequisites for Installation
1. You must install the sharedĆuser Executive software before

installing the sharedĆuser DPS software.

2. You must install the separatelyĆpurchased singleĆuser DPS

software option(s) required for your application. Any number or

combination of DPS software options is permitted.

3. IMPORTANT: The installation procedure for M/N 57C650 below

is used when you initially install the sharedĆuser DPS software. If

you have purchased M/N 57C650 for the purpose of adding

additional users to an existing sharedĆuser DPS installation, you

must use the procedure described in chapter 9.

During the installation procedure, the following subdirectories will be

created on the hard disk if they do not already exist:

<DRV>:\RPE\<AMX3>

<DRV>:\RPE\<AMX3>\TEMP

<DRV>:\AMXWORK

Install the sharedĆuser DPS software on the network server following

the directions below. This procedure must be performed before

installing the sharedĆuser DPS software on each network node.
Step 1.

To begin installing the DPS software, insert the disk

labeled 1" in floppy drive A: or B:.

If you are installing from the Windows Program Manager application,

type the following after selecting Run from the Files menu:

<DRV>:\INSTALL.EXE

where:

<DRV> is the drive in which you have placed the disk.

If you are installing from Windows 95:

Click on Start and choose Run; type

<DRV>:\INSTALL.EXE.

Where:

<DRV>: is the disk drive in which you placed the disk.

Advertising