Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install - Manual (Page 15)

5Ć3
5.2 Installing the SharedĆUser Executive on
Network Nodes
Install the sharedĆuser Executive on each network node that will
access it following the directions below. This procedure must be
performed after installing the sharedĆuser Executive on the network
server.
Note that the procedure described in this section is also used to
install additional 5ĆUser License software on each network node.
Refer to chapter 6 before attempting this procedure.
Step 1.
From a node workstation, log on to the network drive and
directory that contains the Executive software. Type:
WIN INSTALL.EXE
Step 2. A message will be displayed that describes the Shared
User Node Installation. Select OK" to begin the
installation procedure. The Executive *.INI file, AutoMax
startup file, and Norton Editor will be copied to the local
hard drive.
Step 3. A text file, README.AMX, contains information on the
enhancements made for AutoMax V3.x. You will be
prompted for whether you want to read the file or not. If
you select Yes", the file will be displayed. If you select
No", you can read or print out the file later by selecting
the Read Me" icon from the AutoMax V3.x group in the
Windows Program Manager.
Step 4. The following line will be added to the AUTOMAX.INI file
by the install procedure:
EXEC_DRIVE=<drive:\subdirectory>
where <drive:\subdirectory> is the drive and
subdirectory where the Executive software was installed.
Step 5. When the installation has been completed, a message
will be displayed. You have the option of closing Windows
and returning to DOS or returning to the Windows
Program Manager.
Step 6. Install the DPS SharedĆUser option if it is required for your
application.