Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install - Manual (Page 25)

9Ć1
9.0 INSTALLING ADDITIONAL
SHAREDĆUSER DPS
SOFTWARE
The number of users having access to the sharedĆuser DPS
software on a network can be increased by installing as many 5Ćuser
licenses (M/N 57C650) as required. The sharedĆuser Executive
software must already exist on the network.
IMPORTANT: The installation procedure for M/N 57C650 below is
used when you have purchased M/N 57C650 to add additional
users to an existing sharedĆuser DPS installation. If you are installing
M/N 57C650 for the first time to allow up to 5 users to run the
software, you must use the procedure described in chapter 8
instead.
Use the following procedure to add 5 additional DPS users to the
sharedĆuser Executive.
Step 1.
Insert the DPS software disk labeled Add Users" in
floppy drive A: or B:.
Type A:\ADDUSERS <CR> or B:\ADDUSERS <CR>
You will be prompted for the network server directory where the
Executive software is located. The default is
<DRV>:\RPE\<AMX3>
where:
<DRV> is the hard drive where Windows is installed
RPE is the ReSource subdirectory
<AMX3> is the AutoMax V3.x subdirectory
Step 2. Press ENTER to accept the default, or enter the directory
path.
The current number of users will be displayed, and you will be
prompted for the new user limit.
Step 3.
Enter the old number of users plus 5 (five maximum with
each license).
The new total number of users will be displayed.