Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install - Manual (Page 9)

3Ć1
3.0 MAKING A BACKUP COPY
Before you install and use the Executive software and optional DPS
software, you should make a backup copy in case the original is lost
or destroyed. You must use the DOS DISKCOPY command for
backup.
You will need as many formatted floppy disks for the backup
procedure as you have to load the Executive and DPS software.
Follow the procedure below to make backup copies of all disks.
Step 1.
Log onto the C: drive by typing C: at the DOS prompt.
Then type
DISKCOPY A: A: or DISKCOPY B: B:
Step 2. The operating system will prompt you to insert the source
disk into drive A: (or B:). Insert the first disk and strike any
key.
Step 3. The system will then prompt you to insert the target disk.
Replace the source disk with the target (blank) disk and
strike any key. The display will indicate when the
procedure is complete and allow you to copy the
remaining disks without typing the DISKCOPY command
again. Simply answer yes (Y) to the following prompt:
Copy another (Y/N)?
Step 4. Use the above procedure to make a copy of all the disks.