Rockwell Automation 57C600 AutoMax Programming Exec V3.8 (+ Regulators) Install - Manual (Page 14)

5Ć2
If you are installing the upgrade software (M/N 57C621), you will be
prompted that the install procedure requires a previouslyĆinstalled
copy on the network server.
Step 2.
You will be prompted for the drive and subdirectory in
which to install the software. The defaults are as follows:
<DRV>:\RPE\<AMX3>
where:
<DRV> is the network drive where Windows is installed
RPE is the ReSource subdirectory
<AMX3> is the AutoMax V3.x subdirectory
You can make changes to any of the above parameters.
<DRV>:\AMXWORK will be the default working drive and
subdirectory. If you need to change the default, you must do so at
the Setup menu in the Executive.
Step 3.
If AutoMax task skeleton files (SKELETON.*) are found in
the install directory, the install procedure will display a
message stating that the existing AutoMax task skeleton
files (SKELETON.*) have been reĆnamed to USKELTON.*.
The install procedure will install new AutoMax task skeleton files
(SKELETON.*). After the install procedure is completed, you must
update the new skeleton files with any custom information from your
old skeleton files (USKELTON.*), and then delete the old skeleton
files.
Step 4.
The install procedure will begin writing files to the network
server hard drive. After disk 1 is installed, you will be
prompted to replace disk 1 with the floppy disk labeled
2", and so forth for the remaining diskettes. Be sure to
respond appropriately each time to the OK" prompt to
continue the installation. The Executive software will
occupy approximately 7 megabytes of memory on the
hard disk when installed.
You can abort the installation procedure at any point by selecting
Exit. If you abort the installation procedure, you must delete all of
the files in the <AMX3> and TEMP subdirectories.
Step 5.
A text file, README.NET, contains information pertaining
to using the Executive software as a shared program on a
network. You will be prompted for whether you want to
read the file or not. If you select Yes", the file will be
displayed. If you select No", you can read or print out
the file later by selecting README.NET from the
<AMX3> directory list using the Windows File Manager.
Step 6. A message will be displayed that describes how to install
the Executive software onto a node on the network. This
procedure is also described in section 5.2 below. The
node installation procedure should be done immediately
after completing the network server installation
procedure.
Step 7. A message will be displayed stating that the installation is
complete.
Step 8. Run the network node install procedure (see section 5.2)
on each of the network nodes.