Rockwell Automation 8510 AC Spindle Drive System Programming Manual - Manual (Page 12)

2 Chapter
2-9
Programming
Chapter Objectives Chapter 2 provides a detailed look at the programming associated with the
DRIVE SETUP menu found in the 8510. Included are complete
descriptions of the various parameters that can be programmed during
drive setup.
DRIVE SETUP Menu The DRIVE SETUP menu (see Figure 2.1) is the top level of the setup
parameters. The menu is accessed by simultaneously pressing and holding
the Mode, Scroll +, and Scroll – keys for about 3 seconds.
An overall view of the complete DRIVE SETUP menu is shown in
Figure 2.2.
The remaining sections in this chapter provide detailed parameter
descriptions used when programming. After most descriptions, a data
format will be provided. This indicates the entry format expected by the
programming system or the scroll choices that are available. Refer the page
numbers provided in Figure 2.1 to help locate specific programming
information.
Figure 2.1
Drive Setup Menu Tree
DRIVE SETUP
GEAR RANGES
MOTOR SELECT
PARAMETER SET
DRIVE TUNING
ORIENT SETUP
ANALOG OUTPUT
See Page 2-12
See Page 2-14
See Page 2-14
See Page 2-18
See Page 2-29
See Page 2-32