Rockwell Automation 8510 AC Spindle Drive System Programming Manual - Manual (Page 44)

A Appendix
A-41
Parameter Record
Introduction The following list can be used to record final parameter values for
reference at a later date. It is recommended that any changes made to the
parameter values be recorded.
Machine Designation
Location
Date
Name
General Information
Menu 1 Menu 2 Parameter
GEAR RANGES SET RATIOS Spindle Revs
Motor Revs
MOTOR SELECT
Catalog Num
PARAMETER SET ELECT
CONFIG Drive Cat Num
Motor Phasing
Cmnd Phase #1
Cmnd Phase #2
Enable Torque
SPINDL PRESET Overspd Trip
Acc Rate #1
Acc Rate #2
Low Torq Lmt
At-Set-Speed
Speed Detect
Load Detect
1 or 1L 1H 2 or 2L 2H 3 or 3L 3H 4