Rockwell Automation 8510 AC Spindle Drive System Programming Manual - Manual (Page 7)

Introduction
Chapter 1
1-4
Keypad Description and Operation When programming in the DRIVE SETUP menu, the 8510 keypad will
have expanded functions not found in the DISPLAY TYPE menu.
Figure 1.2
8510 Keypad and Display
Display
Keypad
Pressing this key will cause the display to change to the
previous menu level within the DRIVE SETUP menu section.
If the top item of the menu (see Figure 2.2) is shown, the
Mode key will have no effect. If a parameter name and value
are displayed, pressing this key will cause the system to exit
that parameter without saving the displayed value. This key
effectively aborts a selection.
Pressing this key once will cause the parameter or sub-menu
names shown on line 2 of the display to increment to the
next possible choice for the menu listed on line 1. If this key
is pressed and held, the display will continuously index
through the possible selections until the key is released.
When scrolling through a list of sub-menu or parameter
names and the end of the menu list is reached, it will roll
over to the beginning and continue to increment. When
scrolling through parameter value selections, the
incrementing will stop at the end of the list and will not roll
over.
If line 2 is displaying the numerical value of a parameter, a
cursor will be displayed under the least significant digit.
When the Scroll + key is pressed, the value of this digit will
be increased. Pressing and holding this key will cause the
value to increment continuously until the maximum limit for
this parameter value is reached. The scrolling stops at the
maximum limit. The value will not roll over.
continued