Rockwell Automation 1799-D12G12GL 12 Input/12 Output Discrete Embedded I/O - Manual (Page 6)

6 12 Input/12 Output Discrete Embedded TTL I/O Module with Pulse Width Modulation and DeviceLogix
Publication 1799-IN008A-EN-P - July 2005
Valid node addresses are 00 through 63. Each board is shipped with the node
address set to 63 in the board’s memory. The rotary switches are set for position 99
at shipment.
To set the node address, do the following:
1. Use a small blade screwdriver to rotate the switches.
2. Line up the small arrow on the switch with the number setting you wish to
use.
Mount the Module
Use the following illustration to help you mount the module.
You can mount the board in an enclosure with pre-tapped holes.
Use the table on page 2 as a guide when purchasing mounting hardware.
1. Place the six stand-offs behind the module.
2. Align the holes on the module with the stand-offs.
3. Place the screws through the module into the stand-offs and tighten.
TIP
The rotary switches are read at board power-up only. Settings
between 64 and 99 cause the board to use the last valid node
address stored in the board’s memory.
Stand-off (1 of 6)
31570-M