Rockwell Automation 2099-K7KCB-1 Kinetix 7000 DC-DC Converter and Control Board Kits - Manual (Page 11)

Publication 2099-IN002B-EN-P — October 2008
Kinetix 7000 DC-DC Converter and Control Board Kits 11
Replace the DC-DC
Converter Fuse To access the dc-dc converter fuse, the dc-dc converter cassette cover must be
removed.
1. Remove the dc-dc converter cassette cover.
Refer to Remove the Drive Covers on page 4 and follow the procedure
for your drive.
2. Replace the fuse.
Refer to Additional Resources on page 12 for manufacturers datasheet
information.
3. Replace the dc-dc converter cassette cover.
Refer to Remove the Drive Covers on page 4 and reverse the order of
steps for your drive module.
4. Return the drive to operation.
Kinetix 7000 Drive
(2099-BM07-S is shown)
DC-DC Converter Fuse
DC-DC Converter Cassette
LittelFuse
7.5 A, 32V dc
PN 29707.5
IMPORTANT
When replacing the top cover, temporarily remove the
fiber-optic cables from the drive Tx and Rx connectors. This
allows the top cover to seat properly with the chassis.