Rockwell Automation 2099-K7KCB-1 Kinetix 7000 DC-DC Converter and Control Board Kits User Manual
Page 5
Publication 2099-IN002B-EN-P — October 2008
Kinetix 7000 DC-DC Converter and Control Board Kits
5
Remove 2099-BM06-S, 2099-BM07-S, and 2099-BM08-S Covers
Follow these steps to remove the drive covers.
1.
Remove the bottom cover.
a. Pull the cover downward approximately 12 mm (0.5 in.).
b. Pull the cover straight out and away from the drive.
2.
Remove the two dc-dc converter cover screws.
3.
Pull the dc-dc converter cover outward and away from the drive.
4.
Depress the three top cover snap-fits on the right-hand side of the top
cover and pull the cover slightly outward and away from the drive.
5.
Pivot the top cover to the left and maneuver the cover out from under
the slots on the left-hand side of the top cover.
6.
Install your kit.
Kinetix 7000 Drive
(2099-BM07-S side view)
Snap-fits
Top Cover
Side View
Front View
DC-DC Converter Cover
Bottom Cover
Upper DC-DC Converter Cover
Captive Screw
Lower DC-DC Converter Cover
Captive Screw
I/O and Feedback
(IOD, MF, and AF) Connectors
Fiber-optic (Tx and Rx) Connectors
Topic Page
Install the DC-DC Converter Kit