Install the dc-dc converter kit – Rockwell Automation 2099-K7KCB-1 Kinetix 7000 DC-DC Converter and Control Board Kits User Manual
Page 8
Publication 2099-IN002B-EN-P — October 2008
8
Kinetix 7000 DC-DC Converter and Control Board Kits
Install the DC-DC Converter
Kit
Follow these steps to remove and replace the dc-dc converter cassette.
1.
Loosen the upper and lower dc-dc converter screws.
Turn the screws until the latch disengages from the cassette. The upper
screw and latch are shown, the lower screw latches the same way.
2.
Remove the dc-dc converter wiring harness.
Unplug the two connectors and route through slot in cassette.
3.
Pull the dc-dc converter cassette straight out and away from the drive.
4.
Replace the dc-dc converter cassette.
5.
Replace the wiring harness.
Route the two connectors back through the slot in the cassette and
reseat the two-position and three-position connectors.
6.
Tighten the upper and lower dc-dc converter screws.
Turn the screws until the latch engages with the cassette. The upper
screw and latch are shown, the lower screw latches the same way. Torque
screws to 0.45 N•m (4.0 in•lb).
7.
Replace the dc-dc converter cassette and drive covers.
Kinetix 7000 Drive
(2099-BM07-S side view)
Kinetix 7000 Drive
(2099-BM07-S top view)
DC-DC
Converter
Cassette
Upper DC-DC Converter Cover
Captive Screw
Lower DC-DC Converter Cover
Captive Screw
DC-DC Converter
Wiring Harness
DC-DC Converter
Cassette
Captive Screw
DC-DC Converter
Cassette Latch