Rockwell Automation 2099-K7KCB-1 Kinetix 7000 DC-DC Converter and Control Board Kits - Manual (Page 3)

Publication 2099-IN002B-EN-P — October 2008
Kinetix 7000 DC-DC Converter and Control Board Kits 3
Before You Begin Make sure you have the following spare parts, tools, and have removed power
so you can safely remove the drive covers and assemblies.
Parts List
This publication provides installation instructions for removing and replacing
the following components:
• DC-DC converter cassette kit (catalog number 2099-K7KCP-1)
• Control board assembly kit (catalog number 2099-K7KCB-1)
• DC-DC converter fuse (customer supplied)
Required Tools
• Phillips screwdriver
• Flat blade screwdriver
• 3/16 in. thin-walled socket, nut driver, or open-ended wrench
• 1/4 in. thin-walled socket, nut driver, or open-ended wrench
Remove Power
Follow these steps to remove power from your drive.
1. Verify that all control and input power has been removed from the
system.
ATTENTION
Do not remove the Kinetix 7000 drive from the panel. Due to the
physical size and weight of the drives, perform these
procedures with the drive mounted to the panel.
ATTENTION
To avoid shock hazard or personal injury, assure that all
power has been removed before proceeding. This system
may have multiple sources of power. More than one
disconnect switch may be required to de-energize the
system.