Rockwell Automation T3432-CA ICS Regent RTD Input Equipment - Manual (Page 17)

RTD Input Equipment (T3432)
P D - 6 0 3 7 M a r - 0 6
17
Figure 14. Mounting Dimensions for the RTD Termination Panel.
Termination Panel Cable
The termination panel cable connects a RTD input module to
a RTD multiplexer installed in the termination panel. It
carries power to the Mux and routes serial data to the input
module. One end of the cable has a male DB-9 nine-pin
connector that plugs into one of three connectors on the
termination panel. The opposite end should be cut to the
desired length and wired to the I/O chassis terminal block
immediately above the RTD input module. Do not connect the
shield wire at this end. The six wires in the cable are
connected to the I/O slot terminals as shown in Figure 15.