Rockwell Automation 1440-TBS-J XM Dynamic Measurement Module Terminal Base - Manual (Page 14)

14 XM Dynamic Measurement Module Terminal Base
Publication ICM-IN003D-EN-P - March 2013
Interconnect Terminal Base Units
Follow the steps below to install another terminal base unit.
1. Position the terminal base on the 35 x 7.5 mm DIN rail (A).
2. Make certain the side connector (B) is fully retracted into the base
unit.
3. Slide the terminal base unit over tight against the neighboring terminal
base.
Make sure the hook on the terminal base slides under the edge of the
terminal base unit.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail.
If the terminal base does not lock into place, use a screwdriver or
similar device to open the locking tab, press down on the terminal
base until flush with the DIN rail and release the locking tab to lock
the base in place.
5. Gently push the side connector into the side of the neighboring
terminal base to complete the backplane connection.
IMPORTANT
Terminal base units are mounted left to right on the DIN rail.