Rockwell Automation 1440-TBS-J XM Dynamic Measurement Module Terminal Base - Manual (Page 6)

6 XM Dynamic Measurement Module Terminal Base
Publication ICM-IN003D-EN-P - March 2013
Prevent Electrostatic Discharge
About the Terminal Base
WARNING
This equipment must be used only with ATEX-certified Allen-Bradley
backplanes.
WARNING
Secure any external connections that mate to this equipment by using screws,
sliding latches, threaded connectors, or other means provided with this
product.
WARNING
Do not disconnect equipment unless power has been removed or the area is
known to be nonhazardous.
ATTENTION
This equipment is sensitive to electrostatic discharge, which can cause
internal damage and affect normal operation. Follow these guidelines when
you handle this equipment:
• Touch a grounded object to discharge potential static.
• Wear an approved grounding wriststrap.
•
Do not touch connectors or pins on component boards.
•
Do not touch circuit components inside the equipment.
•
Use a static-safe workstation, if available.
•
Store the equipment in appropriate static-safe packaging when not in
use.
IMPORTANT
The 1440-TBS-J terminal base unit is compatible only with
1440-DYN02-01RJ module. Do not attempt to install other XM® modules
on these terminal base units.