Rockwell Automation FactoryTalk Historian SE 3.0 Live Data Interface User Guide - Manual (Page 57)

Chapter 12
51
Error and Informational Messages
The FTLD Interface is based on the PI-UniInt framework, therefore a few
error messages are sent to the PIPC log by PI-UniInt. Other error messages
are sent to the FactoryTalk Diagnostics system. When troubleshooting, we
recommend that you check both FactoryTalk Diagnostics and the PIPC log.
The following is the list of error messages sent to FactoryTalk Diagnostics.
Severity Message text
Error Failed to disconnect from FactoryTalk.
Error Failed to initialize COM library.
Error Failed to initialize COM security.
Error Missing or invalid interface ID parameter.
Error Failed to initialize FactoryTalk Diagnostics.
Error Failed to launch FTLD interface due to the lack of the parameter
/FTDirectory.
Error Failed to launch FTLD interface due to the lack of the parameter
/FTContext.
Error Failed to connect to FactoryTalk Directory scope %s.
Error System error: Insufficient memory.
Warning Failed to remove FactoryTalk Live Data item <%s>.
Warning PI point <%s> is refused because of failure to add FactoryTalk Live
Data item <%s>.
Warning PI point <%s> is refused because of the invalid attribute of Location
[3].