Rockwell Automation 1734sc-IE4CH E+H Instruments via HART to PlantPAx User Manual - Manual (Page 23)

Rockwell Automation Publication PROCES-UM002A-EN-P - July 2014 23
Configure the HART Device in RSLogix 5000 Programming Software Chapter 2
3. On the General tab, enter the configuration information for the module.
4. Click Change.
5. For Input Data, choose Analog and HART PV.
6. On the Configuration tab, enable HART for each channel connected to a
device.
Each channel must be enabled to pass HART data to the controller.