Rockwell Automation MMCL Using the Mining, Mineral, and Cement Library (MMCL) in RSLogix 5000 Appli - Manual (Page 31)

31 Publication RA-UM002B-EN-P - November 2010
Chapter
4
Using the E3 Module
Introduction
The E3p_AOI module is an interface block between Network (scanner) and
Motor block. Templates using the E3 module operate the same as regular
Motor
X module but with the add-on information from the E3 module:
warning status, trip status, therm., utilized and average current. The E3p_AOI
does not have a specific HMI Template. Each Motor Device with E3plus
Overload Relay will call a specific HMI Template such as
03_MotorN_E3_small or 03_MotorN_E3_largel.
There are no parameters to configure inside the E3 module structure.