Rockwell Automation 20D PowerFlex 700S and H Fan Inverter Upgrade Kit (Frame 9) - Manual (Page 13)

Rockwell Automation Publication PFLEX-IN015A-EN-P - March 2005 13
PowerFlex 700S and 700H Fan Inverter Upgrade Kit (Frame 9)
Step 7: Removing the Old
Main Fan
Task Description
Remove the M4x8 Pozidrive screw, which secures the fan inverter cover. Then lift and
pull the plate away from the drive.
Proper tightening torque for reassembly is 3 N•m (27 lb•in).
Disconnect the motor lead wires including the ground wire. Refer to
Figure 1 on
page 20 , when reconnecting the motor.
A
B
1 2 3 4 ON
X6
X1
X4
X5
X7
S1
X2
X8
If a common mode choke is present on
the cover, disconnect and remove it.