Rockwell Automation T8110B/T8110 Trusted TMR Processor - Manual (Page 15)

Trusted
TM
TMR Processor T8110B/T8110
Issue 18 Feb 08 PD-T8110B/T8110 15
ao_discrep_val
The value is specified as 500 counts per volt. It specifies the allowed difference between voltage
readings of Analogue Output channel slices before the TMR Processor indicates a channel
discrepancy.
This applies to 8480 analogue output modules only.
Changes to this value are not implemented until the TMR Processor is rebooted after the download of
the System.ini file.
Format :
ao_discrep_val=xx
Default = 250 (250/500 volts or 500mV).
zim_discrep_val
The value is specified as 500 counts per volt. It specifies the allowed difference between voltage
readings of Zone Interface Module inputs before the TMR Processor indicates a channel discrepancy.
This applies to 8448 ZIM modules (input channels only).
Changes to this value are not implemented until the TMR Processor is rebooted after the download of
the System.ini file.
Format :
zim_discrep_val=xx
Default = 200 (200/500 volts or 400mV).
smm_discrep_val
The value is specified as rpm. It specifies the allowed difference between rpm measurements on a
T8442 speed input channel set before the TMR Processor indicates a channel discrepancy.
This applies to 8442 speed monitor modules (input channels only).
Changes to this value are not implemented until the TMR Processor is rebooted after the download of
the System.ini file.
Format :
smm_discrep_val=xx
Default = 10 rpm.
Note that there is no discrepancy checking on a T8444.