Rockwell Automation 20D PowerFlex 700H/S Frame 13 Replacement Power Structures - Manual (Page 19)

PowerFlex® 700S and 700H Frame 13 Replacement Power Structures 19
Step 5: Installing the
Product Identification Label
on New Power Structure All frame 13 replacement power structures are shipped from the factory
without a product identification label on the drive. If you are installing the
power structures in a 700S drive, you should label it with the accompanying
PowerFlex 700S label. If you are installing the power structures in a 700H
drive, you should label it with the accompanying PowerFlex 700H label.
Step 6: Starting the Drive 1. Install the protective covers and screens and the air flow plate on the
drive. Installation is in the reverse order of removal as indicated in Step
3:
Removing the Old Power Structure on page 3 .
2. Start up the drive. Refer to the Start Up procedures in the appropriate
publication:
– User Manual - PowerFlex 700S Drives with Phase II Control,
20D-UM006…
– Programming Manual - PowerFlex 700H Drives, 20C-PM001…
DC B US CONDUCT
ORS AND CAP
ACIT ORS
OPERA TE A T HIGH VO LTA GE. REMO VE PO WER
AND W AIT 5 MINUTES BEFOR
E SER VICING
DA NGER
!
OR