AJA LUT-box - Manual (Page 18)

LUT-box Mini-Converter v2.1r1 www.aja.com 18
LUT Tab Screen
Figure 17. MiniConfig, LUT Tab Screen
LUT Selections Use the LUT screen to view and make changes to the LUT-box LUT settings. With this
screen you can enable and disable LUT processing and switch between the different
LUTs. The screen has two areas, one for 1D LUTs, and the other for 3D LUTs. The controls in
these two areas perform identical functions for each type of LUT.
Enable : Enables LUT processing. Choose from On or Off. Clicking on the control toggles between
the On and Off states, allowing you to watch the output on a display device as you apply
and remove LUT processing.
Slot: Toggles between the A and B slots. When LUT processing is enabled above, you can A/B
compare between the two sets of LUT data while watching the output on a display
device.
A and B: Displays the file name of the source of the LUT data currently residing in that slot. The file
name of the currently selected slot (whether enabled or not) is displayed in bold text.
See “Write and Read Controls” on page 12 for LUT data Write and Read procedures.