AJA LUT-box - Manual (Page 7)

LUT-box Mini-Converter v2.1r1 www.aja.com 7
I/O Connections
Figure 2. LUT-box Converter
NOTE: The Lock LED indicates valid input video by color. Red is HD video, amber is 3G video, off
is no input.
Installation
Typically, LUT-box installation consists of the following steps:
1. Ensure the LUT-box is disconnected from power.
2. Connect equipment to the SDI input connector(s), and to the SDI out and/or HDMI
out connectors.
3. Connect audio equipment to RCA output connectors (optional).
4. Apply power to the converter (AJA power supply included).
5. The converter will now run using the default factory settings. This default
configuration applies no conversion, passing the incoming video to the outputs, and
routes the first two channels of embedded audio (if present) to the RCA jacks.
6. To use the LUT box you need to load one or two custom LUTs, using MiniConfig:
• Install the AJA MiniConfig software (supplied on CD) on your computer.
• Attach the converter via USB.
• Make your changes using MiniConfig setup screens.
This process is detailed in “USB Control and Setup—Using AJA MiniConfig” on page 9 .
7. When configured with the correct LUT, the LUT-box can be powered down, moved to
the target display, and when powered back up retains those configuration settings.
USB
Port
3G/HD-SDI
Input BNC 1
Signal
Presence
Lock LED
2 Channel
Unbalanced
Analog Audio
Out (RCA Jacks)
DC
Power
Input
DIP switches on bottom.
HDMI
Output
Connector
3G/HD-SDI
Input BNC 2
3G/HD-SDI
Outputt BNC