AJA LUT-box - Manual (Page 8)

LUT-box Mini-Converter v2.1r1 www.aja.com 8
Chapter 2: Operation
DIP Switch Settings
Eight DIP switches are located on the bottom of the unit. The default shipping position
for these switches is Off (left). By default, DIP switch configuration is enabled, and
MiniConfig control is disabled.
The DIP switch label identifies the functions of the switch positions. The LUT-box
originally shipped with a label showing Aux 1, 2, and 3 functions. For LUT-box version 2.0
additional 1D LUT functions were added.
Figure 3. LUT-box DIP Switches
ON OFF
DIP Switches
Version 2.0 Label Original Label
Table 1. LUT-box DIP Switch Setting Descriptions, version 2.0
SWITCH FUNCTION OFF (Left) ON (Right)
1 Control Selects Local (DIP), and
blocks MiniConfig control. Selects Remote (MiniConfig),
and disables DIP switches 2-8.
2 SDI Input
Mode SDI 1 SDI 1+2 (Dual Link)
3 HDMI mode HDMI DVI
4 SDI Pass
Through Apply LUT processing, if
enabled, and any PsF to P
conversion on the SDI output. Bypass LUT processing, if
enabled, and any PsF to P
conversion on the SDI output.
5 1D LUT
Select 1D LUT Slot A 1D LUT Slot B
6 1D LUT
Enable Bypass - No 1D LUT
processing is applied Enable - The selected 1D LUT
processing is applied.
7 3D LUT
Select 3D LUT Slot A 3D LUT Slot B
8 3D LUT
Enable Bypass - No 3D LUT
processing is applied Enable - The selected 3D LUT
processing is applied.