Bang & Olufsen BeoCom 1 - User Guide - Manual (Page 20)

20
>> Daily use
Make and answer calls
The key on the BeoCom 1 is used to start and end a call. During
the call, the phone displays the active line, the duration of the call
and the number or name of the person called. If you do not wish to
answer a call, you can mute the ringing signal.
To make a call…
The current line for outgoing calls appears in the
display. If you wish to use another line, press the
appropriate line key
Enter the telephone number
To correct a digit, turn the wheel to move the
cursor to the digit in question and press C to
delete it
Press to make the call. The call time is shown,
and if the name is stored in the Phonebook, this
is shown as well
Press to end the call. Alternatively, place the
handset in the charger
To answer a call…
Press to answer the call
Press to end a call. Alternatively, place the
handset in the charger
To mute a handset’s ringing…
Press to mute the ringing signal for the incoming
call. The indicator light on the handset flashes
until the caller hangs up the phone
1:Living room
LINE 2
2:Living room
0 – 9
2:5551234567_
2:5551234567
C
2:David Jones
Time: 0:19
2:David Jones
5551234567
C
If you select a primary line for
outgoing calls, as described on
page 36, this line is accessed when
you press . If you have not
selected a primary line, the line last
used for an outgoing call is
accessed.
If you end a call to or from a
number not previously stored in the
Phonebook, the display prompts
you to do so. Refer to Store a
number after a call on page 24 for
more information.
To get a dial tone before entering
the number, press .