Bang & Olufsen BeoCom 1 - User Guide - Manual (Page 54)

54
>> Preference settings
The Settings menu
The Settings menu contains several options which allow you to
connect, disconnect or adjust BeoCom 1 functions.
To choose settings in the menu…
Press to bring up the main menu
Turn the wheel to display Settings and press OK
to bring up the menu
Turn the wheel until the desired option is
displayed, such as Clock
Press to bring up the menu
Turn the wheel to select a setting and press OK
to store it
The Settings menu options
Ringer… This menu contains three separate ringer settings: an on/off
switch, the ringer level (or volume), and the ringer melody. Upon
selecting the Ringer menu, you are prompted to select Line 1, Line 2 or
Intercom. The settings you then choose for the ringer apply only to the
selected line (or to the intercom) for the handset on which you select
the settings.
– ‘Ringer on/off’ lets you switch the ringer on or off, and set a time
period in which the phone will not ring. If you switch off the ringer, the
phone does not ring, but it does register incoming calls in the Caller ID
list. The ringer is disconnected until you change the setting.
– ‘Ringer level’ lets you set the ringer volume. Options are Extra low, Low,
Medium or High. The ringing signal selected is played after a moment.
– ‘Ringer melody’ lets you choose from 8 melodies. If you give the two
lines different melodies, you can hear which line an incoming call is
using.
OK
s Redial list t
s Settings t
OK
s Clock t
OK
Set time
05:20 AM
OK
Options or settings you adjust less
often – perhaps only once – are
available via the Advanced settings
menu, described on pages 56–57.
When you browse through the
Settings menu, the current settings
for each option are shown in the
display. For example, when you
browse to the Clock option, the
current time and date appear on
the second line of the display.