Bang & Olufsen BeoCom 1 - User Guide - Manual (Page 9)

9
To register a handset…
Press to switch on the handset. The display
prompts you to register the handset
Press to continue. The handset searches for an
open base
When a base is located, the PARK number –
which identifies the base – is shown. Check the
number in the display against the number on the
back of the base
If the numbers do not match, turn the wheel to
view the available bases
When the desired base is shown, press to
register the handset to the base. The display
prompts you to wait until registration is complete
If the base prompts you for a pincode, enter the
pincode and press OK
When registration is complete, Enter handset
name? appears in the display. You can then
move on to naming the handset, as described on
page 10. If you do not wish to name the
handset, press C
You can also open a base and
register a handset via the Advanced
settings menu. Refer to the chapter
Preference settings on page 53 for
more information.
OK
Register
handset to base?
OK
Searching base
Wait...
Base 01/01
36-000077000111
OK
Wait...
0 – 9
OK
Enter handset
name?
C