65 for the american market only – Bang & Olufsen BeoCom 1 - User Guide User Manual
Page 65
65
For the American market only…
This equipment complies with Part
68 of the Federal Communications
Commission (FCC) rules for the
United States.
A label is located on the underside
of the base unit containing either
the FCC registration number and
Ringer Equivalence Number (REN).
You must upon request, provide
the following information to your
local telephone company:
USOC Jack Type: RJ11
REN: 0.1B
Should you experience trouble with
this telephone equipment, please
contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights
IL 60004 U.S.A.
Phone:
(847) 590-4900
Main Fax: (847) 255-7805
The REN is used to determine the
quantity of devices which may be
connected to the telephone line.
Excessive RENs on the telephone
line may result in the devices not
ringing in response to an incoming
call. In most, but not all areas, the
sum of RENs should not exceed five
(5.0). To be certain of the number
of devices that may be connected
to a line, as determined by the total
RENs, contact the local telephone
company.
If trouble is experienced with
BeoCom 1, for repair or warranty
information, please contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights,
IL 60004 U.S.A.
Phone:
(847) 590-4900
Main Fax: (847) 255-7805
If the equipment is causing harm to
the telephone network, the
telephone company may request
that you disconnect the equipment
until the problem is resolved.
This equipment cannot be used on
public coin phone service provided
by the telephone company.
Connection to party line service is
subject to state tariffs.
Your telephone company may
discontinue your service if your
equipment causes harm to the
telephone network. They will notify
you in advance of disconnection, if
possible. During notification, you
will be informed of your right to
file a complaint to the FCC.
Occasionally, your telephone
company may make changes in its
facilities, equipment, operation, or
procedures that could affect the
operation of your equipment. If so,
you will be given advance notice of
the change to give you an
opportunity to maintain
uninterrupted service.