Bang & Olufsen BeoCom 1 - User Guide - Manual (Page 8)

8
>> Get started
Charge the handset battery
If the handset requires charging, this occurs automatically when
the handset is placed in the charger. For safety reasons, the battery
is not charged prior to shipping. We recommend that you charge
the handset for at least one hour before proceeding further.
About charging…
– The charger must be connected to the power outlet.
– It takes four hours to fully charge the battery.
– The maximum talk-time per charge is approximately 10 hours.
– Standby time per charge is approximately 150 hours.
First-time registration of a handset to a base
In order for the BeoLine base and the handset to communicate, the
handset must be registered to the base. Up to 8 handsets can be
registered to one base. To register a handset, follow the procedure
described on these pages.
Open the BeoLine base for registration of a handset…
> If you have not connected your base to the power outlet, do so. If the
base is connected, but the indicator light is not flashing red, disconnect
the base, wait two seconds, and reconnect it. The indicator light flashes
red, and the base is open for registration
The handset controls battery
charging, so you can always place
the handset in the charger after
use, even if the battery does not
need recharging. Leaving the
handset in the charger does not
reduce the lifetime of the battery.
The handset display and a beep
signal will inform you when the
batteries require charging. Please
refer to the chapter The handset
display on pages 14–15 for more
information. For more information
about how to handle, place and
connect a BeoLine base, refer to
the Guide enclosed with the base.
Indicator light