Baumfolder Flexifold: Pile Folder (up to 2004) - Manual (Page 20)

TP10456-EN PAGE 20
NOTE: To turn off the Batch Counter, set the Batch Size to zero, 0.
12.0 SINGLE BATCH SETTING
The Single Batch Setting will allow the Pile Feeder process a Single Batch to the desired Batch Size
each time the Sheet Start Key, 4, is pressed. The following instructions will tell you how to set up the
Pile Feeder to run Single Batches at a desired Batch Size.
1. Press the Batch Set Key, 11. The Batch Set screen will be displayed.
The Z digits (flashing) are the batch size. Use the Up/Down keys, 14/13, to set the desired Batch
Size.
2. Press the Enter Key, 7, to enter the data into memory and switched to the Interrupted Time setting.
3. The Y digits (flashing) are the Feed Interrupt Time. Use the Up key, 14, to increase the Interrupt
Time until STOP is displayed.
4. Press the Enter Key, 7, to enter the data into memory and switch to the Count Screen.
13.0 RESETTING THE BATCH COUNTER
The following instructions will allow you to reset the batch Counter. The Total Counter will not be reset.
1. Reset the Batch Counter by pressing the Reset Key, 5. The Reset screen will be displayed.
2. Press the Batch Set Key, 11, and the display will return to the Batch Count Screen with the Batch
Count displaying zero, 0.
COUNT XXXXXXXX
BATCH WWW ZZZZ
COUNT XXXXXXXX
BATCH WWW ZZZZ
BATCH ZZZ
DWELL Y.Y
RESET