Baumfolder Flexifold: Pile Folder (up to 2004) - Manual (Page 26)

TP10456-EN PAGE 26
4. Press the Enter Key, 7, to enter the diagnostic tests or press the Reset Key, 5, to exit. The message
will be displayed, if Enter Key is pressed.
KEYPAD TESTS
PRESS ENTER
5. Press the Up Arrow Key, 14, until the message
is displayed.
OUTPUT TESTS
PRESS ENTER
6. Press the Enter Key, 7, and the message
will be displayed.
7. Using the Up/Down Arrow Keys, 14/13, select the output test of interest. In the table on the next
page, there is a list of each output test available in this diagnostic program, along with remarks on how the
chosen output should function normally.
8. To exit the sensor tests, use the Up Arrow Key, 14, until the message
is displayed.
9. Press the Enter Key, 7, and the operator panel will return to the
screen.
FEED WHEEL TEST
VERIFY OFF
PRESS ENTER
TO EXIT TESTS
OUTPUT TESTS
PRESS ENTER
10. Use the Up Arrow Key, 14, until the message
is displayed.
11. Press Enter Key, 7, and the operator panel display will return to the main count screen.
PRESS ENTER
TO EXIT TESTS