Baumfolder Flexifold: Pile Folder (up to 2004) - Manual (Page 9)

PAGE 9 TP10456-EN
2.0 INTRODUCTION
The Flexifold Pile Feeder is a modular
addition to the Flexifold Folding System. This feeder
has these features that adds value to the folding
system.
- Higher load capacity - 18 inch (45.8cm)
stack
- Register - aligns the paper prior to folding
for improved folding accuracy.
- Gap size - allows for larger gaps between
sheets, allowing for better folding on some
fold configurations
- Sheet counter
- Batch counter
- Speed slaved to the first folding station
- Single sheet operating mode for ease of set
up
- Ability to vary sheet gap
- Pile table reload position at a constant
height
- Jam or not running inhibit from first fold
station (parallel)
3.0 SPECIFICATIONS
Model Name Flexifold Pile Feeder
Minimum Sheet Size 4x6” (10.2 x 15.2cm)
Maximum Sheet Size 14 x 20” (35.5 x 50.8cm)
Maximum Paper Weight 65 lb Cover
Maximum Stack Height 18” (45.7cm)
Overall Dimensions
Height
42.5” (108cm)
Width 33.1” (84.0cm)
Length 51.2” (130.0cm)
Operating Voltage 230VAC/1PH/50Hz
115VAC/1PH/60Hz
Supplied Power 230VAC/1PH/50Hz/25AMPS
115VAC/1PH/60Hz/25AMPS
Mating Connector 230VAC - CEE7
115VAC - NEMA5-30R
4.0 PILE FEEDER & REGISTER
INSTALLATION INSTRUCTIONS
1. If applicable, remove existing short pile
feeder from parallel folding unit. Be sure to disconnect
both hoses.
2. Register will drop directly into parallel
folding unit by aligning the four locating slots in the
register side frames with four locating pins in the
parallel unit.
3. Install register drive guard onto register
drive gear block after register has been installed on
parallel folding unit.
4. Roll pile feeder unit to register. There is one
locating block w/pin on each side of feeder. There is
also one locating slot in each register side frame for
locating pins in blocks on feeder. Register side frames
should fit in between locating blocks on feeder. Pile
feeder has four height adjustable casters, adjust these
up and/or down until locating pins on pile feeder slide
into slots on register side frames. Now lock feeder
into place by rotating locking pawls on register frames
over pins in locating blocks on pile feeder.