Baumfolder Flexifold: Pile Folder (up to 2004) User Manual
Page 22
TP10456-EN
PAGE 22
16.0 RUN FAULT ERROR MESSAGES
These error messages may occur during setup or a production run.
ERROR MESSAGE
REMARKS
INHIBIT
1st Station is not running, check wiring to controller board.
DOUBLE SHEET
Remove the double sheet, check sensor, wiring to controller board
17.0 CONTROLLER LED LIST
The following is a list of LEDs and their associated circuit located on the controller.
18.0 DIAGNOSTIC PROGRAM
The diagnostic program contains several routines that will test the operator keypad, test the controller
sensors, test the controller output circuits and test the panel indicators.
D1
Pile Reload Sensor
D2
Table Enable
D6
Direction
D10
Pile Height Sensor
D11
Double Sheet Detector
D13
Table Up Safety Limit Switch
D14
Table Down Safety Limit Switch
D15
Table Down Limit Switch
D18
Feed Enable
D19
Speed
D21
Pump
D23
Motor AC
D35
+12 Vdc Switched
D40
+5 Vdc Logic Power
D42
+12 Vdc Power
LED
DESIGNATION
ASSOCIATED
CIRCUIT
18.0.1 PILE FEEDER KEYPAD SWITCH TESTS
This test will provide a way of checking the operation of the switches on the operator keypad. During
this test, all outputs from the motors, sensors, etc. are turned off. Also, you may exit this diagnostic program at
any time by pressing the Diagnostic Key, 5.