Brandmotion 1009-9517 - Manual (Page 13)

INSTALLATION INSTRUCTIONS
1009-9000-00 13 of 18
9 August 2011
35. Reinstall the end of dash cap by placing it
on the end of the dashboard and firmly
pressing it into place with your hands.
36. Reinstall the A-Pillar cover by sliding it into
place and using a 10mm socket and bolts
that were removed earlier, then reinstall the
bolt covers.
37. Route the chassis harness behind the rear
cab mount and out to the inside of the
vehicle. Wire tie the chassis harness in
between the cab and bed mount using one
wire tie. (Figure 26)
Figure 26
38. The supplied chassis harness continues on
to follow the existing wiring harness along
the inside edge of the frame rail. Wire tie
the supplied chassis harness to the existing
wiring harness using nine wire ties.
39. Once the chassis wiring harness has been
routed to the back of the bed, coil and wire
tie any excess length on the harness.
(Figure 27)
Figure 27