Brandmotion 1009-9517 - Manual (Page 15)

INSTALLATION INSTRUCTIONS
1009-9000-00 15 of 18
9 August 2011
46. Drill a starter hole at the center punch mark.
Then use a hole cutter to cut a 1” hole in
the endgate. (Figures 32 & 33). Clean the
rough edges using a deburring tool.
Figure 32
Figure 33
47. Remove lock rod retainers by unclipping the
red tabs with your fingers (Figure 34).
Remove the nuts attaching the handle to the
endgate using a 8mm socket, and then
remove the handle from the endgate.
(Figure 35)
Figure 34
Figure 35
48. If equipped, remove the lock cylinder from
existing handle and remount the cylinder in
the supplied handle using a 8mm socket.
(Figures 36, 37 and 38) Note: If the
existing handle is not equipped with a lock,
install the provided plastic plug into the lock
opening.
Figure 36