Brandmotion 1009-9517 - Manual (Page 8)

INSTALLATION INSTRUCTIONS
1009-9000-00 8 of 18
9 August 2011
17. Reinstall the overhead console by sliding the
tabs on the front of the console into the
headliner then pushing the tabs on the back
of the unit straight up into the headliner.
18. Reinstall the sun visor using a 8mm socket.
19. Reinstall the sun visor anchor using a T20
Torx driver.
20. Remove the front driver’s side kick panel/sill
plate by lifting it at the rear and working
your way forward with your hands. (Figure
13)
Figure 13
21. Remove the rear drivers-side sill plate by
lifting it at the front and working your way
back with your hands. (Figure 14)
Figure 14
22. Lift the driver’s side rear seat to expose the
under seat storage compartment. Pull three
pushpins out of the driver’s side rear seat
storage compartment using a pushpin
removal tool (Figure 15). Pull back the
carpeting and remove the body floor plug,
then clean off excess caulking on the floor
to ensure the supplied chassis harness
grommet will seat properly. (Figure 16)
Figure 15
Figure 16