Brandmotion 1009-9517 - Manual (Page 17)

INSTALLATION INSTRUCTIONS
1009-9000-00 17 of 18
9 August 2011
53. Route the wiring harness through the 1”
hole that was cut using the supplied
template. (Figure 42)
Figure 42
54. Apply corrosion protection (ZTech) to 1”
hole that was cut using the supplied
template. (Figure 43)
Figure 43
55. Seat the grommet affixed to the camera
harness into the 1” hole by firmly pressing it
with your fingers. (Figure 44)
Figure 44
56. Reinstall the handle access panel on the
inside of the endgate using a T30 Torx
driver and the existing hardware.
57. Feed the wiring harness through the
rectangular hole in the back of the truck
bed. (Figure 45)
Figure 45
58. Reinstall the endgate by lifting it into place,
rotating it down about ten degrees and
sliding it to the left.
59. Reinstall both endgate straps by placing the
large opening of the endgate strap hangers
over the endgate strap mounts and pulling
down.