Brandmotion 2000-3811 - Manual (Page 14)

Section 5: Toyota 4-Runner, 2010 - Current
2000-3811 Instructions 8-1-13.Doc Page 14 of 54
13. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS unit’s dip switches
are all set to the “down” position – “DDDDD”:
14. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
15. Unplug the small 4-pin connector from DPS module.
16. Set the DPS dip switches for Toyota 4-Runner. The
second and fifth switches should be flipped to the
“up” position – “DUDDU”:
17. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
18. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
19. Turn ignition key to “LOCK” (OFF) and remove key.
20. Secure DPS module using supplied 24” wire ties.
21. Reassemble vehicle.
22. Use a 50/50 mix of alcohol and water to clean dash
surface before installing the DPS badge.