Brandmotion 2000-3811 - Manual (Page 21)

Section 7: Toyota Camry, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 21 of 54
24. Set the DPS dip switches for Camry according to
vehicle year using the following chart:
Model
Years
DPS Dip Switch Setting
2013 –
Current
Camry
“UDDUD”
2010 –
2012
Camry
“UDDDD”
25. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the
4-pin connector from the DPS module and wait
another 10 seconds.
26. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should
now be sound from the speakers). Ensure radio
head unit is working properly including all speaker
channels.
27. Turn ignition key to “LOCK” (OFF) and remove key.
28. Slide supplied 24” Wire Ties under factory harness.
29. Place DPS module over Wire Ties and tighten to
secure module. Use side cutters to trim excess.
30. Re-install removed parts in reverse order of removal.
31. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge.