Brandmotion 2000-3811 - Manual (Page 34)

Section 12: Toyota Prius, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 34 of 54
14. Reinstall radio.
15. Reconnect negative battery cable using a 10mm
Socket. Re-torque battery bolt to 36 inch lbs.
16. Place DPS module with the Bongiovi DPS Acoustics
side face down. Confirm the DPS module’s dip
switches are all set to the “down” position –
“DDDDD”:
17. Turn ignition key to “ON” making sure radio is on.
(Note: There should be no sound from speakers).
18. Unplug the small 4-pin connector from DPS module.
19. Set the DPS dip switches for Prius. The second and
fourth switches should be flipped to the “up”
position – “DUDUD”:
20. Plug the small 4-pin connector back into the DPS
module and wait 10 seconds. (Note: There should
again be no sound from the speakers). Unplug the 4-
pin connector from the DPS module and wait another
10 seconds.
21. Again, plug the 4-pin connector back into the DPS
module. (Note: After a short delay, there should now
be sound from the speakers). Ensure radio head unit
is working properly including all speaker channels.
22. Turn ignition key to “LOCK” (OFF) and remove key.
23. Secure DPS module to heater box using supplied 24”
Wire Ties. Use side cutters to trim excess wire tie.
24. Re-install removed parts in reverse order of removal.
25. Use a 50/50 mix of alcohol and water to clean dash
surface before installing DPS badge.