Brandmotion 2000-3811 - Manual (Page 43)

Section 16: Toyota Tundra & Sequoia, 2010 – Current
2000-3811 Instructions 8-1-13.Doc Page 43 of 54
1. Ensure all radio functions are working properly,
return all Treble, Bass, Fade, and Balance to neutral
settings and, remove any CDs to avoid possible jam
before disassembly.
2. For vehicles equipped with automatic transmissions,
place shifter in the N (neutral) position and set
parking brake.
3. Loosen the negative battery cable bolt. Remove
negative battery cable from terminal and position
away from battery.
4. Lower the steering column, and move gear selector
to Low. Use a Plastic Trim Removal Tool to loosen
the upper instrument panel.
5. Pull the upper instrument panel out to provide
clearance for the HVAC panel. Do not disconnect the
upper instrument panel.
6. Use a Plastic Trim Removal Tool to unsnap the four
clips retaining the HVAC control panel and pull the
panel out. Lift slowly and carefully to avoid damage
to attached wires.
7. Disconnect all electrical connectors behind the HVAC
control panel.
8. Use a 10mm socket or Phillips head screwdriver to
remove the four 10mm hex bolts retaining the radio.
Release the three clips retaining the radio.
9. Remove radio head unit taking care not to damage
attached wires. Disconnect all connectors.
Note 1: Disassembly instructions vary according to
transmission type and seating arrangement.
Note 2: DPS module settings vary according to body
style, year, and audio system options.
Refer to instructions for full details.
FIG
5