Calculated Industries 5070-A User Guide - Manual (Page 18)

U
ser
'
s
G
Uide
— 17
♦ Third Press
Shows Fill Percentage for the calculated
Conduit Size as determined by NEC
Table 1, Chapter 9.
♦ Fourth Press
Shows the Total Wire Area for all entered Wires.
♦ Fifth Press
Shows Remaining Fill Area. This value may be
negative if all Wires are the same size due to
Note 7 in NEC Chapter 9, Table 1.
 
conduit type (cond type) — Used to select
the desired Conduit Type. Pressing these keys
with a value between 1 and 12 will select the
corresponding Conduit Type, as specified in the
list below (i.e.,    selects the EMT
Conduit). Continuous presses of   toggle
through the available Conduit Types.
♦ First Press
Displays the currently selected Conduit Type.
1) eMT
2) enT
3) fMC
4) IMC
5) lfnb
6) lfna
7) lfMC
8) RMC
9) P-80
10) P-40
11) P-a
12) P-eb