Calculated Industries 5070-A User Guide - Manual (Page 56)

U
ser
'
s
G
Uide
— 55
aPPenDIX a — DeFaUlt SettiNGS
After a Clear All ( ), your calculator will return to the following
settings:
sToReD Values DefaulT Value
Insulation Rating 60º C
Wire Type Rating Copper
Phase 3Ø
Ambient Temperature 30º C (86º f)
Volts 240V
Voltage Drop % 3%
Power Factor % 100%
Efficiency % 100%
Motor Type Induction
Conduit Type eMT
Fuse/Breaker Motor Type squirrel Cage non Design e
Overload FLC% 115%
Free Air Mode* off
* This setting will also return to its default upon turning the calculator off
and back on.
If you replace your batteries or perform a Full Reset* (Press ,
hold down  and press ) your calculator will return to the
following settings (in addition to those listed above):
PRefeRenCe seTTInGs DefaulT Value
NEC Code 2011
Ambient Tempurature Units °C
Length Units feeT
* Depressing the Reset button located above the  key will also
perform a Full Reset.