Metrohm 757 VA Computrace - Manual (Page 116)

5 Determination mode
757 VA Computrace – Software
106
Comments
Display of comments if any type of error appeared in the
sweep (e.g.
Ovl. in scan = Overload during sweep; Ovl. in
CDE = Overload during cleaning or deposition; Ovl. in
cond. cycles = Overload during conditioning cycles; No
peak found = no peak found for defined substance; Not
used = peak is not used for calculation).
Calibration data
Substance
Substance name (see Substance on the Substances tab,
section 5.2).
Calibr.
Calibration technique std.add. , rec.cc. , or smp.cc. (see
Calibration on the Specifications tab, section 5.4).
Y.reg/offset
Evaluation quantity for the sample calculated from the
standard addition curve (for standard addition) or inter-
cept of the calibration curve (for calibration curves).
Slope
Slope of the standard addition or calibration curve.
Mean deviat.
Calculated mean deviation of the measured values about
the standard addition or calibration curve.
Solutions
No. Number of Dosimat used for addition or predose.
Content
Remarks regarding the solution (see Content on the DO-
SIMATS window, section 5.2).
Vol. (mL)
Volume of the exchange unit installed on the Dosimat
(see
Volume on the Hardware tab, section 2.7).
Predose (mL)
If the Dosimat is used for solution predose, the message
Predose X.X mL is displayed in this column.