Metrohm 757 VA Computrace - Manual (Page 14)

1 Introduction
757 VA Computrace – Software
4
Installation of software and add-on board
1. Switch off PC and disconnect power cable from the power
socket.
2. Disconnect all other cables to computer peripherals (key-
board, display, printer, etc.).
3. Disassemble PC and install 3.757.1300 Add-on Board in a
free ISA slot (see instruction manual of the PC).
4. Reassemble PC.
5. Switch off 757 VA Computrace Stand.
6. Connect the built-in add-on board to the "PC Interface" socket
of the 757 VA Computrace Stand with the 6.2135.010 cable.
7. Switch on 757 VA Computrace Stand and PC and start oper-
ating system (Windows™ 98 or Windows™ 2000).
8. Insert installation CD into CD drive.
9. If the autorun option for the CD drive is disabled, select
<Start> and Run . Browse for the Setup.exe file on the installa-
tion CD and click on <OK> .
10. Click on " 757 " and follow the instructions given in the setup
program. Select the Add-on Board (3.757.1300) option for the in-
terface type.
11. The software package will be installed in the desired directory
(the default directory is Programs/Metrohm/757 VA Computrace ).
In addition to the program files, the following folders are in-
stalled:
Data
Folder for storage of new signal ( *.sig ) and determi-
nation files ( *.dth ).
Demo data
Folder containing signal and determination file ex-
amples. The subfolder
Practical Voltammetry
contains
all examples of the 8.757.5003 Metrohm Mono-
graph "Practical Voltammetry", which is available
from Metrohm on request.
Method
Folder for storage of method files ( *.mth ). You find
some basic examples in the Method folder and more
examples in the subfolders Application Bulletin , Ap-
plication Notes and Hardware Test .
Hardware
Folder for hardware control files and drivers.
12. Restart the PC.
13. Start the VA Computrace software.