Metrohm tiBase 1.0 Manual - Manual (Page 286)

4.8 Subwindow curves ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
278 ￭￭￭￭￭￭￭￭ tiBase 1.0
Only editable when autoscaling is disabled.
Range
-1.00E+12 ... +1.00E+12
Default value 1000
Curve
Curve color
Selection of the color for the curve line.
Selection 13 colors | blue
Default value blue
Symbol
Selection of the symbol for the display of the individual measuring points.
Selection ● | ╳ | ✸ | ￭ | ▲ | No symbol
Default value No symbol
No symbol
Measuring points are not shown.
Note
With curves, for which the distance between to measuring points is
smaller than 5 pixels, the separate measuring points are not displayed
anymore, even if a symbol has been selected. In this case, the graphics
window can eventually be enlarged in order to display the symbols again.
Symbol color
Selection of the color for the measuring point symbol.
Selection 13 colors | blue
Default value blue
Smoothing
Smoothing
on | off (Default value: on)
Switches smoothing on/off for the curve.
Smoothing factor x axis
Factor for smoothing on the x axis.
Range 0.01 ... 1000
Default value 0.01