Metrohm tiBase 1.0 Manual - Manual (Page 33)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 General program functions
tiBase 1.0 ￭￭￭￭￭￭￭￭ 25
Variable
name
(PC-Control)
Variable
name
( tiBase 1.0 )
Description Command
.ESI# .EP{x}.MEP Marking for the endpoint x (1...9);
1 = 1 endpoint, 2 = 2 or more
endpoints DET, MET, SET, KFT
.EP# .EP.QTY Measured value (water) for the
endpoint in mg KFC
.ET# .EP{x}.TEM Temperature for the endpoint x
(1...9) in °C DET, MET, SET, KFT
.ED# .EP{x}.TIM Time for the endpoint x (1...9) in
s DET, MET, SET, KFT, KFC
.EP# .EP{x}.VOL Volume for the endpoint x (1…9)
in mL DET, MET, SET, KFT
.MCT .ETE End temperature (temperature
following processing of the com-
mand) in °C DET, MET, SET, KFT, KFC,
STAT, MEAS (without T/
Flow), CAL MEAS, STDADD,
DOS
.MCV .EVT End volume (total dosed volume
at the end of the command) in mL DET, MET, SET, KFT, STAT,
DOS
.FM# .FP{x}.MEA Measured value for the fixed end-
point x (1…9) in the unit of the
measured value DET, MET, SET, KFT, STAT
.FP{x}.QTY Measured value (water) for the
fixed endpoint x (1...9) in mg KFC
.FT# .FP{x}.TEM Temperature for the fixed end-
point x (1…9) in °C DET, MET, SET, KFT, STAT,
MEAS (without T/Flow)
.FD# .FP{x}.TIM Time for fixed endpoint x (1…9)
in s DET, MET, SET, KFT, KFC,
STAT, MEAS (without T/
Flow)
.FP# .FP{x}.[VOL] Volume for the fixed endpoint x
(1...9) in mL DET, MET, SET, KFT, STAT
.HM# .HP{x}.MEA Measured value for HNP x (1...9)
in mV
1)
DET, MET
.HT# .HP{x}.TEM Temperature for HNP x (1...9) in
°C DET, MET
.HD# .HP{x}.TIM Time for HNP x (1...9) in s DET, MET
.HP# .HP{x}.[VOL] Volume for HNP (half neutraliza-
tion potential) x (1...9) in mL DET, MET
#M.MIM .IME Initial measured value (measured
value before start conditions are
processed) in the unit of the
measured value (number) DET, MET, SET, KFT, STAT,
MEAS, CAL MEAS,
STDADD, DOS